Before Operation; Walking Axle Assembly - Schulte GLADIATOR RWP-1935 Operator's Manual

BEFORE OPERATION

THE MACHINE IS SHIPPED WITHOUT OIL. FILL PUMP GEARBOX WITH GEAR OIL AND
THE COOLER/RESERVOIR WITH HYUDRAULIC OIL BEFORE OPERATING.
Refer to the Maintenance Section of this manual for recommended oil type and viscosity.
Lubricate all grease fittings. Refer to the grease schedule in this manual.
Remove both chain case covers and check that the drive chains are properly tensioned and lubricated.
Refer to the Maintenance Section of this manual.
Check that all nuts and bolts are in place and properly tightened. Refer to the Maintenance Section of this
manual for proper bolt grades and toques.
Some items may appear different than your machine, or have different colors to highlight parts being used.

WALKING AXLE ASSEMBLY

Bolt the Walking Axle Mount onto the main frame
as shown. Match plate profile to ensure proper
orientation.
.
Mount the Walking Axle in the orientation shown
(Axle Mount Sleeves up). Be sure to install
retaining bolts in BOTH ends of the pin.
.
Gladiator RWP-1935 01/23
© 2023 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-2