Table of Contents
Advertisement
Be particularly careful when transporting the Implement using the tractor. Turn curves or go
up or down hills only at a low speed and at a gradual steering angle. Make certain that at
least 20% of the tractor's weight is on the front wheels to maintain safe steerage. Slow down
on rough or uneven surfaces.
Only tow the Implement behind a properly sized and equipped Tractor which
exceeds the weight of the Implement by at least 20%.
Implement behind a truck or other type of vehicle. Never tow the Implement
and another Implement connected in tandem. Never tow the Implement at
speeds over 20 MPH.
Secure the Implement for transport before traveling on public roads.
Implements, secure the center axle using cylinder stops or transport pin and properly attach
a safety chain between the Implement and Tractor. Secure wings in upright position on
folding Implements using wing transport locks.
Your driving vision may be reduced or impaired by the tractor, cab, or implement. Before
driving on public roadways identify any limited vision areas, and make adjustments to your
operating position, mirrors, and the implement transport position so that you can clearly see
the area where you will be traveling, and any traffic that may approach you. Failure to
maintain adequate vision of the public roadway and traffic can result in serious injury or even
death.
Raise the unit to the transport position and secure with the retaining pins before traveling on
public roads and when storing.
MAINTENANCE AND SERVICE SAFETY INSTRUCTIONS AND
PRACTICES
Relieve hydraulic pressure prior to doing any maintenance or repair
work on the Implement. Place the Implement on the ground or securely
blocked up, disengage the PTO, and turn off the tractor engine. Push
and pull the Remote Cylinder lever in and out several times.
Disconnect and remove the Implement hydraulic hoses from the tractor
prior to starting any maintenance or repair work.
Always maintain the safety signs in good readable condition. If the safety signs are missing,
damaged, or unreadable, obtain and install replacement safety signs immediately.
Do not modify or alter this Implement.
Implement, any of its components or any Implement function.
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause death or
serious injury.
Gladiator RWP-1935 01/23
© 2023 Alamo Group Inc.
SAFETY
(STI-01) str
(STI-06)str
(STI-10)
(SG-14)str
Safety Section 1-9
(STI-7) str
(STL-15) str
(STL-17) str
Do not permit anyone to modify or alter this
DO NOT tow the
For pull-type
(SG-5)str
(SG-8)str
Advertisement
Table of Contents
