Table of Contents
Advertisement
6. Please check the airflow direction and fan orientation (Hydraulic Fan Drive). The fan should spin counter
clockwise direction by pulling air through the cooler and blowing it towards the fan motor.
7. Reduce the engine speed to idle and disengage the PTO.
8. Oil should be changed after 10 hours of operation to get rid of any contaminants from the system or based
on hydraulic manufacturer's requirements.
NOTE: If there are any leaks during start up, shut down the system immediately and inspect/tighten the lines
leaking connections. Please consult factory if you continue to see this problem.
9.4 Operating the Wings
This implement uses cylinders to fold and unfold the wings. Make sure that the hydraulic lines and wing fold
cylinders are purged of air by fully extending and retracting cylinders a minimum of 6 times on double acting
cylinders. On single acting cylinders raise and lower the wings a minimum of 6 times. Only operate the
implement with both wings completely lowered.Never operate the implement with a raised wing. Wait until the
drums have come to a complete stop before raising wings. Ensure wings are fully raised and secured using the
transport lock pins before transporting the implement.
When the Wings are folded for transport, the center of gravity is raised and the possibility of
overturn is increased. Drive slowly and use extreme caution when turning on hillsides.
Overturning the Implement could cause the Implement to overturn the Tractor and vice versa
resulting in serious injury or even death. Never fold wings on a hillside...the Implement or unit
may overturn.
Use extreme care when lowering or unfolding the implement's wings.
bystanders are close by or underneath the wings. Allow ample clearance around the
implement when folding or unfolding the wings. Use extreme caution around buildings or
overhead power lines.
Gladiator RWP-1935 01/23
© 2023 Alamo Group Inc.
OPERATION
(STI-02) str
(S3PT-05) str
Operation Section 4-26
Make sure no
Advertisement
Table of Contents
