Table of Contents
Advertisement
Start tractor only when properly seated in the Tractor seat. Starting a
tractor in gear can result in injury or death. Read the Tractor operators
manual for proper starting instructions.
Never run the Tractor engine in a closed building or without adequate ventilation. The
exhaust fumes can be hazardous to your health.
6. CONNECTING THE IMPLEMENT TO THE TRACTOR
Use extreme caution when connecting the Implement to the tractor. The implement should be securely resting
at ground level or setting on blocks. Keep hands and feet from under the implement frame and clear of pinch
points between the tractor hitch arms and implement pins.
Always shut the Tractor completely down, place the transmission in park, and set the
parking brake before you or anyone else attempts to connect or disconnect the Implement
and Tractor hitches.
6.1 Connecting the Implement
1. Make sure the tractor is equipped with the
correct drawbar.
2. Block the unit wheels in place and use the
attached parking jack to raise or lower the
tongue clevis to the height of the tractor
drawbar.
Note: Always place jack foot on firm surface or
place board under jack for support.
3. Board the tractor and start the engine. Back
the tractor to the unit aligning the drawbar hitch
hole with the unit hitch clevis. Install the hitch
pin. Turn off the tractor engine, set the parking
brake, place the tractor in park, and dismount.
4. Securely attach unit safety chain to tractor
drawbar or drawbar support frame.
5. Insert the Draw Pin and ensure the Draw Pin
retainer is secured.
6. Lower the jack until the tongue is completely
supported by the drawbar. Remove jack from
the tongue and place on storage bracket of
unit main frame.
7. Finally, attach the hydraulic hoses.
8. Connect implement warning light plug into
tractor electrical receptacle.
DHX-360/DHX-600
03/21
© 2021 Alamo Group Inc.
OPERATION
(SG-13)
(S3PT-15)
Operation Section 4-8
(SG-23)
Advertisement
Table of Contents
