Table of Contents
Advertisement
The AC supplies are routed to each terminal block through an appropriate strain relief mounted
on the knockout plates.
3. To open the AC input area of the projector, remove the six screws holding the cover and swing
the cover downwards to open it.
4. Taking the approved line cord for your location, strip the cable jacket on the line cord to
expose a 120 mm length of the bundled wires.
CP4445-RGB and CP4455-RGB Installation and Setup Guide
020-103746-01 Rev. 1 (11-2022)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
30
Advertisement
Table of Contents
