Table of Contents
Advertisement
A
48V power supply A AC input
B
48V power supplies A and B
C
48V power supply B AC input
D
12V power supply
E
12V power supply AC input
Before connecting the UPS device, make sure the projector is disconnected from power.
1. Remove the rear cover of the projector by loosening the six screws.
2. Disconnect the IN-LINE input plug from the 12V power supply.
3. Remove the protective cap from the UPS plug.
4. Connect the IN-LINE connection labeled UPS to the 12V power supply.
5. Place the protective cap from the UPS plug on the IN-LINE input plug.
6. Re-install the rear panel of the projector.
7. Obtain the appropriate line cord for your region, plug the cord into the UPS device, and then
plug it into the UPS inlet on the projector.
CP4445-RGB and CP4455-RGB Installation and Setup Guide
020-103746-01 Rev. 1 (11-2022)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
32
Advertisement
Table of Contents
