Projector components (rear)
A
Touch panel
A touch-sensitive screen used to control the projector.
B
Power cord, AC receptacle, and AC circuit breakers, and fire alarm interlock terminal
C
Air exhaust
D
Service access door
Preparing the installation site
Ensure the installation area is ready for the components.
1. Clear the installation area.
2. Post laser hazard warning signs at all entry doors.
3. Place each component near its installation location.
Lifting and positioning the projector
Safely lift and position the projector in the location where it will be used.
Warning! If not avoided, the following could result in death or serious injury.
•
A minimum of four people or appropriately rated lift equipment is required to safely lift, install,
or move the product.
•
Do not install or operate the projector in any position that does not meet the stated product
specifications for alignment and orientation.
CP2309-RGB Installation and Setup Guide
020-103078-01 Rev. 1 (06-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Installing and setting up
15