Table of Contents
Advertisement
•
A qualified electrician is required to connect the chiller unit to AC power. For detailed
information, refer to the documentation provided by the chiller manufacturer.
•
For electrical rating information, refer to the license label on the chiller. Additional information is
available in the chiller's product documentation.
1. Remove the cover for the power supply terminal by unscrewing the two cover screws.
2. Make sure the rubber grommet is installed on the cable at the connector end.
The grommet provides strain relief protection for the power cable.
3. Connect the L, N, and PE harness connectors to the corresponding terminals.
CP4445-RGB and CP4455-RGB Installation and Setup Guide
020-103746-01 Rev. 1 (11-2022)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
39
Advertisement
Table of Contents
