Table of Contents
Advertisement
Safety precautions
Learn about the safety precautions related to the Christie CP4445-RGB and CP4455-RGB projector.
This projector is intended for use in a cinema environment.
General safety precautions
Read all safety and warning guidelines before installing or operating the projector.
Warning! If not avoided, the following could result in death or serious injury.
•
TRIP OR FIRE HAZARD! Position all cables where they cannot contact hot surfaces, be pulled, be
tripped over, or damaged by persons walking on or objects rolling over the cables.
•
This product must be installed within a restricted access location not accessible by the general
public.
•
Only personnel who are trained on the precautions for the restricted access location can be
granted entry to the area.
•
Install the product so users and the audience cannot enter the restricted area at eye level.
•
ELECTRICAL and BURN HAZARD! Use caution when accessing internal components.
•
High leakage current. Earth or ground connection essential before connecting power.
•
FIRE AND SHOCK HAZARD! Use only the attachments, accessories, tools, and replacement parts
specified by Christie.
•
FIRE HAZARD! Do not use a power cord, harness, or cable that appears damaged.
•
HAZARDOUS SUBSTANCE! Use caution when handling the product as it contains ethylene glycol.
Do not ingest coolant. For information on safe handling, refer to the Safety Data Sheet (SDS) for
the coolant.
•
Lift equipment must be used to position the product.
•
Do not install or operate the projector in any position that does not meet the stated product
specifications for alignment and orientation.
Caution! If not avoided, the following could result in minor or moderate injury.
•
Only Christie qualified technicians are permitted to open product enclosures.
Laser safety precautions
Read all safety and warning guidelines before operating the projector laser.
Warning! If not avoided, the following could result in death or serious injury.
•
Do not operate the cinema projector without all of its covers in place.
•
LASER RADIATION HAZARD! This projector has a built-in Class 4 laser module. Never attempt to
disassemble or modify the laser module.
•
RADIATION HAZARD! Use of controls or adjustments, or performing procedures other than those
specified may result in hazardous radiation exposure.
•
Do not look directly into the lens when the light source is on. The extremely high brightness can
cause permanent eye damage.
•
Possible hazardous optical radiation emitted from this product. (Risk group 3)
CP4445-RGB and CP4455-RGB Installation and Setup Guide
020-103746-01 Rev. 1 (11-2022)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Introduction
7
Advertisement
Table of Contents
