Enabling Or Disabling Security - Sun Microsystems SPARCstorage Library User Manual

1

1.6.1 Enabling or Disabling Security

1-8
•
Changing the SCSI IDs
•
Changing the library serial number
•
Changing SCSI parity checking
•
Using the Diagnostics Menu and the Demo Menu
•
Using the Clean Drives Menu
•
Opening the front door (LCD security only)
•
Communicating with a tape drive across a serial port
If a user attempts to perform any of the above operations when security is
enabled, the Main Screen displays a message that states security is active. The
message also states whether security was enabled through the LCD or SCSI.
Note – Security remains in effect even after you reset the tape library.
1. Select the Configuration Menu by pressing
2. Select Set Security On/Off (depending whether security is already
on or off) by pressing
3. Select a three digit password.
To disable security, enter the same password used to turn security on.
a. Move from column to column by pressing
b. Change the password (default password is 000) by pressing
c. Press Enter to make the password active.
Note – If you forgot the password, try entering the default password - 000.
SPARCstorage Library X-Option Rack-mounted User's Guide—June 1995
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
← →
or .
↑ ↓
or .