Sun Microsystems SPARCstorage Library User Manual page 81

ASC ASCQ
Byte 12 Byte 13
40h 86h
40h 87h
40h 88h
40h 89h
40h 90h
40h 91h
40h 92h
40h A0h
40h A2h
40h A3h
40h A4h
40h A5h
40h B0h
40h B1h
40h B2h
40h B3h
40h B4h
40h B5h
40h E4h
Table A-4 Hardware Error Sense Key (4h) ASC and ASCQ Values (Continued)
Display Description
Panel
Number
07 -12-volt power supply failure.
08 Digital/analog converter failure.
72 The front door is open or the door solenoid is malfunctioning.
77 The tape library was not in the correct control mode when the command
was executed.
To invoke commands from the Maintenance Menu, the tape library must
be in LCD Interface mode.
To run the SunDiag system exerciser, the tape library must be in one of
the Sequential modes (Sequential CTS1, Sequential CTS2, or Dual
Sequential).
Under normal operation, the tape library must be set to SCSI Interface
mode.
20 The gripper home sensor did not clear.
21 A gripper error occurred.
22 A gripper motion took longer than the maximum time allocated for it.
When motion functions do not complete in the allocated time, current to
the servo motors is cut off.
30 The CHM could not move along the short axis.
32 The motor on the short axis failed.
36 The tape library could not reset the servo chip for the short axis.
37 The servo busy bit on the short axis failed.
73 The CHM could not reach its destination on the short axis.
40 The CHM could not move on the long axis.
41 The CHM could not return to home position on the long axis.
42 The motor on the long axis failed.
46 The tape library could not reset the servo chip for the long axis.
47 The servo busy bit on the long axis failed.
70 The CHM could not reach its destination on the long axis.
99 One of the motors is stalled. The tape library must wait for it to cool
down before operations can resume.
Error Codes
A
A-9