Sun Microsystems SPARCstorage Library User Manual page 32

2
2.2.1.2 SCSI Interface Mode
2.2.1.3 Sequential 1, Sequential 2, or Dual Sequential Modes
2-4
To run certain tests in the Maintenance Menu, you must set the tape library in
LCD Interface mode.
1. Select the Interface Menu by pressing
2. Select the Control Mode Menu by pressing
3. Select LCD Interface mode by pressing
You can now execute commands in the Configuration Menu, the Maintenance
Menu, or the Library Information Menu.
In the SCSI Interface mode, the host computer system issues SCSI commands
to the tape library to specify how cartridges are loaded and unloaded from the
removable cartridge holder and to access the tape drives.
To set the tape library to SCSI Interface mode:
1. Disable security.
2. Select the Interface Menu by pressing
3. Select the Control Mode Menu by pressing
4. Select SCSI Interface by pressing
Set the tape library to Sequential 1, Sequential 2, or Dual Sequential mode in
order to run the SunDiag system exerciser. If only one tape drive is installed,
only Sequential 1 mode is displayed.
1. Check to see if there are any tapes in the tape drives by checking if the
bottom LED is steadily flashing or on steadily.
If there are tapes in the tape drives, you must remove them.
If the bottom LED is flashing:
a. Open the door.
SPARCstorage Library X-Option Rack-mounted User's Guide—June 1995
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.
↓ ↑
or , then Enter.