Clutch Coil Continuity Test
This test can be performed the same way on both the
Warner and Orgura clutches.
1. Disengage PTO.
2. Raise the seat and disconnect the negative battery
cable from the battery.
3. Unplug the harness connector from the clutch (Fig.
544).
Fig 544
4. Using a continuity tester, touch one tester lead to
one of the clutch terminals and the other lead to the
clutch housing.
5. If the tester shows a resistance reading, the field has
failed and needs to be replaced.
Z580/Z589 DFI Z Master Service Manual
PICT-3933a
ELECTRICAL
6
6-19