Motion Control Damper Replacment; Motion Control Damper Removal - Toro Z580 DFI Z Master Service Manual

CHASSIS
27. Position the floor pan assembly (Fig. 224).
3
28. Install both floor pan assembly hinge bolts and nuts
(Fig. 225).
29. Install the negative battery cable from the battery.
30. Lower the seat.
3-62
Fig 224 PICT-3053a
Fig 225 PICT-3052a

Motion Control Damper Replacment

There is a right and a left motion control damper. The
following removal and installation procedures are done
on the right damper. The procedure is the same for the
left damper.

Motion Control Damper Removal

1. Park the machine on a level surface, disengage the
PTO, turn the ignition off and remove the key.
2. Raise the seat.
3. Remove the negative battery cable from the battery.
4. Remove the outer nut from the bolt on the lower end
of the damper (Fig. 226).
Fig 226
Z580/Z589 DFI Z Master Service Manual
PICT-3171a