Wheel Motor Installation
Note: As a reminder, prior to connecting the hy-
draulic lines, the o-rings should be replaced
with new ones and lightly lubricated with
petroleum jelly.
Note: There are two different spacers used on the
wheel motors (Fig. 307). The short spacers
are used in the front of the wheel motor (with
the brake linkage) and the long spacers are
used to retain the back of the wheel motor.
A
Fig 307
A. Short spacer
Z580/Z589 DFI Z Master Service Manual
B
DSC-2117a
B. Long spacer
HYDRAULIC SYSTEM
1. Insert the wheel motor into the frame. Loosely install
the 2 rear wheel motor mounting bolts, long spacers
and nuts (Fig. 308).
Fig 308
2. Swing the brake linkage into position (Fig. 309).
Fig 309
4
PICT-3377a
PICT-3374a
4-21