Checking The Hydraulic Lines And Hoses; Inspecting The Hydraulic-System Test Ports; Mower Maintenance; Pivoting (Tilting) The Front Mower Deck Upright - Toro Groundsmaster 5910 Operator's Manual

10. Start the engine and use all of the hydraulic controls to
distribute hydraulic fluid throughout the system. Check
for leaks, then shut off the engine.
11. Check the fluid level and add enough to raise level the
level to the Full mark on the dipstick.
Important: Do not overfill.
Checking the Hydraulic Lines
and Hoses
Service Interval: Every 2 years—Replace moving hoses.
Inspect the hydraulic lines and hoses daily for leaks, kinked
lines, loose mounting supports, wear, loose fittings, weather
deterioration, and chemical deterioration. Make all necessary
repairs before operating the machine.
Inspecting the
Hydraulic-System Test Ports
The test ports are used to test the pressure in the hydraulic
circuits. Contact your local Toro distributor or refer to the
Toro Service Manual for assistance.

Mower Maintenance

Pivoting (Tilting) the Front
Mower Deck Upright
Note: Although not needed for normal maintenance
procedures, you can pivot (tilt) the front mower deck upright.
1. Raise the front mower deck slightly off the floor.
2. Perform the premaintenance procedure; refer to
Preparing the Machine for Maintenance (page
3. Remove the retainer clip and disconnect the damper
assembly from the mower deck
1. Damper assembly
4. Remove the hairpin cotter and clevis pin securing the
height-of-cut chains to the rear of the mower deck
(Figure 91).
58
(Figure 90).
Figure 90
2. Retainer clip
39).