Furuno SFD-1010 Operator's Manual page 20

1. BASIC OPERATION
When operating radar: TLL
⑤
When operating fish finder:
Fixed mark, TLL
When using radar:
⑥
[PICTURE CONTROL] menu
When using fish finder:
[POPUP] menu
When using multi beam
sonar:
[POPUP] menu
[POWER/BRILLIANCE]
⑦
1-2
Outputs TLL.
•
Displays fixed mark at selected location.
•
Outputs TLL.
•
Opens/closes the [PICTURE CONTROL] menu.
•
Adjusts the gain, sea clutter reduction level and
•
rain clutter reduction level. Rejects interference
and noise.
The menu cycles through gain, sea clutter, rain
•
clutter, picture zoom, interference rejection and
noise rejection.
Opens/closes the [POPUP] menu.
•
The menu cycles through [Auto Range] →
•
[Range] → [Modes] → [Auto Gain Adjust] →
[Offset HF] → [Offset LF] → [Gain Adjust HF]
→ [Gain Adjust LF] →
Opens/closes the [POPUP] menu.
•
Moves through [POPUP] menu. The selections of
•
[POPUP] menu differs after [Range Auto] →
[Range] → [Mode] according to the selected
mode.
- Multi beam fish finder mode: Moves as [MB
Gain Auto] → [MB Gain Offset] → [MB Gain]
→ [MB Beam Angle] → [MB Beam Width] →
- Side scan mode: Moves as [SS Gain Auto] →
[SS Gain Offset] → [SS Gain] →
- Cross section mode: Moves as [CS&3D Gain
Auto] → [CS&3D Gain Offset] → [CS&3D
Gain] →
- 3D History mode: Moves as [CS&3D Gain
Auto] → [CS&3D Gain Offset] → [CS&3D
Gain] → [Pause]/[Resume] →
When the power is off.
•
- Turns power on.
When the power is on.
•
- Short press: Displays the [BRILLIANCE] menu.
- Pressing and holding for two seconds: Displays
the power-off notification menu.
- Pressing and holding for five seconds: Turns
the power off.