Gps Antenna Position] Menu; Motion Sensor Setup] Menu - Furuno SFD-1010 Operator's Manual

[Transducer Mismount Correction]: Data correction when
the transducer is installed 180°in the opposite direction.
[Bow(-)/Stern(+)], [Up(-)/Down(+)], [Port(-)/Starboard(+)]:
Refer to section 5.11 about these menus.
[Transmission Power Auto]: Turn on to automatically
adjust TX power.
[Transmission Power]: Select the strength of
transmission for when [Off] is selected on [Transmission
Power Auto] menu.
[Transmission Rate Mode], [Transmit Rate]: Select the
transmission rate to be changed [Manual] or [Auto].
When [Manual] is selected on [Transmission Rate
Mode], the [Transmit Rate] can be adjusted between [0]
and [20].
5.9.2

[GPS Antenna Position] menu

Refer to section 5.11 regarding [Bow(-)/Stern(+)], [Up(-)/Down(+)] and [Port(-)/
Starboard(+)] of this menu.
Touch control:
1. Press the MENU/ESC key to open [MENU].
2. Tap [SYSTEM].
3. Tap [GPS Antenna Position].
Related menus appear.
Key control:
1. Press the MENU/ESC key to open [MENU].
2. Select [SYSTEM] with arrow keys, then press the ENTER key.
3. Select [GPS Antenna Position] with arrow key, then press the ENTER key.
Related menus appear.
5.9.3

[Motion Sensor Setup] menu

Refer to section 5.11 regarding [Bow(-)/Stern(+)], [Up(-)/Down(+)] and [Port(-)/
Starboard(+)] of this menu.
[Roll Sensor Offset], [Pitch Sensor Offset]: Apply an offset to the internal roll and pitch
sensors. (Seeting range: -45 to +45)
[Motion Sensor Synch. (in ms)], [Heading Sensor Synch. (in ms)], [Position Sensor
Synch. (in ms)]: Set the offset time to synchronize the received signal from each sensor.
5. INSTALLATION
5-31