UNI-T UPO2102 User Manual page 77

User's Manual
depth to automatic.
c. Trigger setting：In hold mode, remain source and trigger coupling setting, other setting will restore
to "edge trigger, automatic, rising edge."
d. Signal setting：Remain the channel state.
(9) Clear Data
Clear can delete stored waveform and the setting file in the oscilloscope.
(10) SCPI Port
SCPI port configuration can allocate USB and UART. The default setting is USB.
(11) Internet Setting
When the device is connected with available internet, IP setting can set the IP, subnet mask and gateway
of the oscilloscope.
a. Mode：Switch IP acquire mode, it can set manual or auto.
Manual：Set IP address, subnet mask and gateway by manual
Auto：Only for checking IP address, subnet mask and gateway
b. IP Address：IP address format is nnn.nnn.nnn.nnn，the first nnn range is from 1 to 233, the second
nnn range is from 0 to 255. It is recommended that user can consult network administrator for an
available subnet mask.
c. Subnet mask：The format is nnn.nnn.nnn.nnn，the nnn range is from 0 to 255. It is recommended
that user can consult network administrator for an available subnet mask.
d. Gateway： The format is nnn.nnn.nnn.nnn， the first nnn range is from 1 to 233, the second nnn range
is from 0 to 255. It is recommended that user can consult network administrator for an available
subnet mask.
(12) RTC Setting
RTC can set the time of the oscilloscope. User can separately set year, month, date, hour and second.
Switch the setting item by key. After the setting is completed, the oscilloscope will display the setting
time.
Note：If RTC time is networking and synchronizing the internet time, the adjustment will not take effect.
(13) Boot Loading
Boot Loading can set whether to automatically set the settings before the shutdown when the
oscilloscope starts up. It can set the last setting or the default setting.
Last setting: Load all the settings before shutdown;

Default setting: Restore the oscilloscope to the default factory setting after starting up.

(14) Power-on Mode
Set the power-mode of the oscilloscope, it can set always off, always on and last status.
Always off: After the power switch on the rear panel of the oscilloscope is turned on, user should press

the soft boot key by manual on the front panel of the oscilloscope. Then the oscilloscope will power on.
Always on: After the power switch on the rear panel of the oscilloscope is turned on, the oscilloscope

will directly power on.
 Instruments.uni-trend.com
MSO/UPO2000 Seri es
77 / 137