UNI-T UPO2102 User Manual page 134

User's Manual
In XY mode, this function cannot
be use！
Start to update？
The channel is not open！
Turn on allow to test！
Waveform reference channel is
not open, there is no valid data！
It's not allow to test in XY and the
main window mode ！
Turn off scanning！
There is no opened channel,
please turn on channel to
record！
In Multi-Scopes, LA is forbidden!
In FFT split screen mode, this
function is invalid！
In FFT split screen mode,
Pass/Fail test is forbidden！
The file list is empty！
Auto-calibration is canceled！
Restored to factory setting,
internet parameter is not
change！
Shunt down, please wait...
Turn off quick record and set
record interval！
No correct license is detected.
Confirm the purchase and try
again！
Activation is successful！
This function is not activated,
please purchase activation
code！
The function is in trail. If need to
use it in the long run, please
purchase activation code！
 Instruments.uni-trend.com
It will be prompt when open MATH, REF, LA, DECODE function in XY
mode.
It will be prompt when select the update file to upgrade.
It will be prompt if the selected channel is not opened in cursor
measurement, Pass/Fail template, channel waveform storage,
arbitrary waveform storage function.
It will be prompt when allow to test function is disabled.
It will be prompt if REF is not loading adjusting horizontal or vertical
when waveform reference is select REF in Pass/Fail test.
It will be prompt when Pass/Fail test and XY mode is enabled.
It will be prompt if press other key when it in scanning.
It will be prompt if all analog channel is turned off when in recording
waveform.
It will be prompt when turn on Multi-Scopes function and then open
LA.
It will be prompt when using Pass/Fail test, bode diagram, reload
waveform, LA function in FFT split screen, waterfall curve mode.
It will be prompt when turn on Pass/Fail test function and then open
FFT split screen.
It will be prompt when if the filename is empty when reload
reference waveform, the setting file and bode diagram.
It will be prompt if press MENU key to cancel auto-calibration when
in auto-calibration.
It will be prompt when SCPI is connect the internet to send factory
setting command.
It will be prompt when the oscilloscope is shutting down.
It will be prompt when set the time interval in quick record.
It will be prompt if there is no correct license when insert USB to
activate the optional.
It will be prompt when activation license is selected in USB.
It will be prompt when select the optional after the trail is ended.
It will be prompt if select the optional when it in trail.
MSO/UPO2000 Seri es
134 / 137