Rear Panel; Operation Panel - UNI-T UPO2102 User Manual

User's Manual

4.4 Rear Panel

1. EXT Trig: Input port of external trigger or external trigger /5
2. OUT: Output port supports AUX Out and AWG CHB for function/arbitrary waveform generator
3. VIDEO Out: VGA video signal output, it can convert screen to VGA output
4. USB Device：USB device interface, use this interface to communicate with PC
5. LAN: Use this interface to connect the oscilloscope to local area network for remote control
6. AC Power Input Socket: AC power input port. Use power cord supplied with accessory to connect the
oscilloscope to AC power (power supply requirements of this oscilloscope 100～240 V, 50/60Hz).
7. Power Switch: Turn on power switch after AC socket is connect properly, the oscilloscope can be power
on normally. Press "power supply soft key" on the front panel to boot the oscilloscope.
8. Safety Lock: Safety lock (sold separately) can be used for the oscilloscope stay at fixed position

4.5 Operation Panel

(1) Vertical Control
③ REF: For recall reference waveform stored in "internal or U flash dish". It can compare the actual
 Instruments.uni-trend.com
1
1 , 2 , 3 , 4 : Analog channel setting key, it represents CH1, CH2, CH3,
①
CH4 separately. Four channel identified by different colors and the color also
corresponding to waveform on the screen and channel input connector. Press any
key to turn on the related channel menu (to active or disable channel).
② MATH: Press this key to open the mathematical operation menu for add, subtract,
multiply, divide, FFT, digital filtering and advanced operations.
4 5
2 3
Figure 4-4 Rear Panel
MSO/UPO2000 Seri es
6 7
8
15 / 137