Table of Contents
Advertisement
12. Troubleshooting
If a problem occurs while operating the equipment, perform the corresponding
troubleshooting measures outlined in the table below. If the problem persists, please
contact our customer support staff.
If the equipment is not working
Cause
Failure of power supply
Initialization status
Failure of the Control
PC's connection
If the Exposure Switch is not functioning
Cause
Failure of readiness
If imaging cannot be performed
Cause
Failure of initialization
If the Laser Beam has shut off and patient positioning cannot be performed
Cause
Expiration of the time
allotted for patient
positioning
PCT-90LH User Manual
Check the equipment's power supply.
Wait until the equipment has been initialized and then
try again.
Check the connection status of Communication Port
(Optic) which connects the PC to the equipment.
Check whether the Console Software is ready for
imaging.
Wait until the equipment is initialized and then try again.
If this problem persists, restart the equipment.
Press the Laser Beam button to turn on the Laser
Beam.
If a problem occurs during image acquisition, press the red
Emergency Stop Switch to immediately stop all moving parts and cut
off all power to the equipment's electrical components. You may then
safely release the patient from the equipment. To restart the
equipment, turn the Emergency Stop Switch clockwise until it pops
up.
Do not allow any liquid in the vicinity of the machine. Moisture may
cause extensive damage to the equipment's electrical components.
12. Troubleshooting
Actions to be taken
Actions to be taken
Actions to be taken
Actions to be taken
141
Advertisement
Table of Contents
