Troubleshooting - Vatech PAX-I User Manual

8. Troubleshooting

8.
102
Troubleshooting
If a problem occurs while operating this equipment, perform the corresponding
troubleshooting measure outlined in the table below. If the problem persists,
please contact our customer support staffs.
- If the device is not moving
Cause
Power failure
Initialization status
Control PC
connection failure
- If the exposure switch is not functioning
Cause
Ready status
- If imaging cannot be performed
Cause
Initialization status
- If the laser beam has shut off and patient alignment cannot be
performed
Cause
The time allotted for
patient alignment
has expired
- Do not allow any liquids in the vicinity of the machine
as moisture may cause extensive damage to this
equipment's electrical components.
-
- If a severe problem occurs during image acquisition,
WARNING
press the red emergency stop button to immediately stop
all moving parts and cut off all power to the equipment's
electrical components. You may then safely release the
patient from the equipment.
Solution
Check the equipment's power supply.
Wait until the equipment has initialized and then try
again.
Check the connection status of Serial Port (RS232)
which connects the PC to the equipment.
Solution
Check whether it is ready for capturing the imaging
program.
Solution
Wait until the equipment has initialized and then
try again. If this problem persists, restart the
equipment.
Solution
Press the laser beam button to turn on the lasers
and then carry out patient alignment.
PaX-i (PCH-2500) User Manual