12. Cleaning And Maintenance; Cleaning - Vatech GREEN SMART User Manual

12. Cleaning and Maintenance

12.1

Cleaning

Thoroughly clean the areas of the equipment that come in direct contact with the

patient, such as the Chinrest and the Bite.
Do not use spray cleaners or solvents as they could flow into the equipment and

damage the electrical components or cause a fire.
Do not use abrasive liquids such as acetone, gas, or oil, which may cause corrosion

on the surface of the equipment.
Do not use any cleaning products which contain silicon. They could potentially

damage the equipment's electrical components.
The following table summarizes the standard cleaning procedures to be performed by the
operator.
Components
(Normal Bite, Special Bite A,
and Special Bite B)
Temple Supports
Chinrest
Computer and peripherals
Outer covers of equipment
Green Smart User Manual
The equipment has to be installed and maintained on a flat surface.
Always turn off the power to the equipment and disconnect it from the
power outlet before cleaning.
Bite
Clean with ethanol and gently wipe with a dry
towel before the next patient.
Clean with ethanol and gently wipe with a dry
towel before the next patient.
Clean with ethanol and gently wipe with a dry
towel before the next patient.
Follow the manufacturers' instructions found in the
accompanying manuals.
Wipe the unit with a dry cloth at the end of each
day.
Do not use cleaning agents in aerosol or spray form directly on the
surface of the equipment.
12. Cleaning and Maintenance
Cleaning Process
131