Factory Configuration - Wilo Geniax Central Control User Manual

Technical information
13.2 Technical data
Electronics
Electromagnetic compatibility
Emitted interference
Interference resistance
Protection class
Protection class
Materials
Housing
1) In the range of +15 to +25°C
2) Device active, display lighting switched on
3) can be activated/deactivated via the termination switch (DIP switch) at the Central Control

13.3 Factory configuration

Temperature pre-settings
Comfort temperature
Energy saving temperature
Minimum temperature
Maximum temperature
Room frost protection tempera-
ture
Temperature in the day period
End of the day period
Temperature in the night period
End of the night period
User manual Wilo-Geniax Central Control
EN 55022
EN 61000-6-3
EN 61000-6-2
IP 20
II
Lower part of housing: Plastic PC-ABS
Housing, upper part: Plastic PMMA/PC
The normally used factory-saved values are presented in
the following table.
21°C The default value of the Geniax System which
is suggested when creating a new time area
in the week profile.
16°C The default value of the Geniax System for
absence.
10°C The lowest room temperature which can be
set for the building/rooms.
30°C The highest room temperature which can be
set for the building/rooms.
8°C The frost protection temperature set for all
rooms in the building by the Geniax System.
The value of the frost protection temperature
can be below the minimum temperature.
21°C The temperature set by the Geniax System
for presence.
22:00 hrs The end of the day period set by the Geniax
System.
16°C The temperature set by the Geniax System
for absence.
06:00 hrs The end of the night period set by the Geniax
System.
English
109