Aquacal Water Source WS03 Installation Manual page 74

IF UNIT IS ASLEEP,
SWIPE TO WAKE UP
PRESS "ENTER"
C
ARROWS TO "FREEZE
3
PROTECT ENABLED"
MENU TO EXIT, PRESS
& HOLD TO STATUS
Adjusting Freeze Protection Options
NOTICE
Use extreme care when setting and adjusting freeze protection options. Improper freeze protection settings can
l
cause damage to equipment. This is not covered by heat pump warranty.
Available freeze protection options:
"PROTECT ON SETPOINT" can be adjusted from 33° F to 39° F (.6° C to 4° C). The
l
default is 37° F (3° C).
"PROTECT OFF SETPOINT" can be adjusted from 40° F to 45° F (4° C to 7° C). The
l
default is 42° F (5.5° C).
"CYCLE TIME" can be adjusted from 5 to 20 minutes. The default is 5 minutes.
l
"ACTIVE TIME" can be adjusted from 15 to 120 minutes. The default is 60 minutes.
l
IF UNIT IS ASLEEP,
SWIPE TO WAKE UP
Page - 70
PRESS "MENU"
A
BUTTON
USE ARROWS TO
1
GROUP TO EDIT
PRESS "ENTER"
4
TO EDIT
Failure to heed the following may result in damage to equipment.
PRESS MENU
A
BUTTON
USE ARROWS TO
B
"GROUPS"
PRESS "ENTER"
2
TO EDIT
USE ARROWS TO
5
CHANGE TO "ON"
USE ARROWS TO
B
"SYSTEM"