Connecting An External Controller (Optional); Poolsync - Aquacal Water Source WS03 Installation Manual

Available Ports:
Circulation Pump:
l
"Port B" (RS-485 Connector) - Normally used for
l
Variable Speed Circulation Pumps.
Actuators:
l
Port "VA Return"
l
Port "VA Intake"
l
Port "VA Solar"
l
Relays:
l
Relay "A" - The default for Single Speed Circulation
l
Pumps.
Relay "C"
l
Relay "D"
l
Figure 1

1.4 Connecting an External Controller (Optional)

To support a direct connection to an external controller, AquaCal
removable terminal blocks on the control board. The control board is located on the low-voltage side of the
electrical enclosure.
PLEASE NOTE
If using an external control device, other than a PoolSync
not directly control a circulation pump. (Presets for that option will not be shown if a
third party external control device is configured).
®
1.4.a PoolSync
Page - 18
IN THIS SECTION:
1.4.a PoolSync®
1.4.b SMART Controllers
1.4.c 2-wire Controllers (Pool-Spa)
1.4.d 3-wire Controllers (Pool-Off-Spa)
Select heat pumps will automatically allow for WI-FI
capabilities using a PoolSync
®
The PoolSync device will allow direct control of the
l
heat pump from a mobile device.
Contact installing dealer to order this product.
l
Go online and download the PoolSync
l
information on connecting and using this device with an
AquaCal heat pump.
manuals/
Confirm the PoolSync
l
control device. See "Confirm PoolSync® is set to
operate" on the facing page.
® heat pumps are equipped with
®
, the AquaCal heat pump will
®
.
®
manual for
https://www.aquacal.com/owners-
®
has been set as an active external
18
20
23
24