Pool / Spa, No Valves, No Pump - Aquacal Water Source WS03 Installation Manual

Select the appropriate preset for the site conditions.

Pool / Spa, No Valves, No Pump

When pressed, the "Pool/Spa" button will display with three choices:
1. Pool - With an initial timer set for 48 hours at 85° F.
2. Spa - With an initial timer of 2 hours at 96° F (104° F with an installed OTA kit).
3. Schedules - Without an active schedule, the heat pump mode is initially set to "OFF".
Page - 36
PRESET OPTIONS:
Pool / Spa, No Valves, No Pump
Pool / Spa, No Valves, Pentair VS
Pool / Spa, No Valves, Hayward VS
Pool / Spa, No Valves, Jandy VS
Pool / Spa, No Valves, Single Speed
Pool / Spa, Valves, Pentair VS
Pool / Spa, Valves, Hayward VS
Pool / Spa, Valves, Jandy VS
Pool / Spa, Valves, Single Speed
Pool Only. No Valves, No Pump
Pool Only, No Valves, Pentair VS
Pool Only, No Valves, Hayward VSS
Pool Only, No Valves, Jandy VS
Pool Only, No Valves, Single Speed
Spa Only, No Valves, No Pump
Spa Only, No Valves, Pentair VS
Spa Only, No Valves, Hayward VS
Spa Only, No Valves, Jandy VS
Spa Only, No Valves, Single Speed Circulation Pump
Use Setup from USB
This preset configures the heat pump as
follows:
No valve actuator is configured.
l
No circulation pump is configured.
l
No schedules are configured.
l
36
37
37
37
38
38
38
39
39
39
40
40
40
41
41
41
42
42
42
43