Pool / Spa, Valves, Jandy Vs; Pool / Spa, Valves, Single Speed; Pool Only. No Valves, No Pump - Aquacal Water Source WS03 Installation Manual

Pool / Spa, Valves, Jandy VS

When pressed, the "Pool/Spa" button will display with three choices.
1. Pool - With an initial timer set for 48 hours at 85° F.
2. Spa - With an initial timer of 2 hours at 96° F (104° F with an installed OTA kit).
3. Schedules

Pool / Spa, Valves, Single Speed

When pressed, the "Pool/Spa" button will display with three choices.
1. Pool - With an initial timer set for 48 hours at 85° F.
2. Spa - With an initial timer of 2 hours at 96° F (104° F with an installed OTA kit).
3. Schedules

Pool Only. No Valves, No Pump

When pressed, the "Pool/Spa" button will display with two choices:
1. Pool - With an initial timer set for 48 hours at 85° F.
2. Schedules - Without an active schedule, the heat pump mode is initially set to "OFF".
This preset configures the heat pump as
follows:
Two actuator valves are configured named
l
intake (on "VA INTAKE") and return (on
"VA RETURN").
A Jandy variable speed circulation pump
l
is configured.
A pool schedule is configured (Everyday
l
from 8:00 am to 6:00 pm)
This preset configures the heat pump as
follows:
Two actuator valves are configured named
l
intake (on "VA INTAKE") and return (on
"VA RETURN").
A single speed circulation pump is
l
configured to use the relay "A" connection
point on the expansion board.
A pool schedule is configured (Everyday
l
from 8:00 am to 6:00 pm)
This preset configures the heat pump as
follows:
No valves actuators are configured.
l
No circulation pump is configured.
l
No schedules are configured.
l
Page - 39