Configuring Groups; Create A Group - Aquacal Water Source WS03 Installation Manual

1.6.i Configuring Groups
A group is used to control multiple devices (equipment) connected to the heat pump, either by manually
activating the group through a shortcut, or scheduling the group to activate at a specified time.
i.1 Create a Group
EXAMPLES OF GROUPS THAT CAN BE CREATED:
o Backyard Lights Group
A pool light and a spa light that have been connected and configured by the heat pump installer
o
can be activated upon demand.
o Cold Plunge Group -
A spa can be set to "COOL" to a desired temperature upon demand.
o
o Custom Group -
A custom group can be created that heats the water to a desired temperature without effecting
o
another user's settings.
The example below shows a "BACKYARD LIGHTS" group being created manually.
Two devices will be set to an operating state of "ON" when the group is active.
A pool light relay
l
A spa light relay
l
IF UNIT IS ASLEEP,
SWIPE TO WAKE UP
PRESS "ENTER"
C
USE ARROWS TO NAME
3
"BACKYARD LIGHTS"
Page - 46
EXAMPLES IN THIS SECTION:
i.1 Create a Group
i.2 Edit a Group
i.3 Delete a Group
PRESS "MENU"
A
BUTTON
USE ARROWS TO
1
"NEW GROUP SETUP"
ENTER TO SAVE
4
USE ARROWS TO
B
"GROUPS"
ENTER TO CREATE
2
USE ARROWS TO SET
5
MAXIMUM ACTIVE TIME
46
48
49