Set A Desired Temperature (Setpoint) For The Heat Pump To Activate; Setting Entry Code Option - Aquacal Water Source WS03 Installation Manual

1.6.d Set a desired temperature (setpoint) for the Heat Pump to activate
Press the up or down arrow to set the desired temperature (setpoint) for the water.
The heating indicator will illuminate when heating the water.
l
The cooling indicator will illuminate when cooling the water.
l
PLEASE NOTE:
The maximum allowed set temperature for a Water Source unit is 96° F (35.6° C).
l
If an over temperature safety device has been installed, the maximum allowed set
l
temperature is 104° F (40° C). See "Over Temperature Alarm Kit" on page 64.
An over temperature safety device comes standard for SunPower equipment.
l
PLEASE NOTE:
The heat pump will not operate if incoming water temperatures are above 110° F (43°
C). If sustained water temperatures will fall below 32° F (0° C), the equipment must be
winterized in order to prevent damage. See "Winterizing" on page 84.
NOTE:
If a group's schedule is active and the temperature setpoint is changed, that group's
temperature setpoint will also be changed.
HEAT THE WATER
1
Use Mode Button to Select
1.6.e Setting Entry Code Option
The entry code feature can prevent unauthorized access to the heat pump adjustments. This feature initiates
after the heat pump goes into the sleep mode for the first time. This feature is commonly used on
commercial applications.
NOTICE
Before enabling the entry code feature, be sure to record the code. If lost, the heat pump will require a
l
program reset to regain access. This reset may require additional configuration by the installer.
IF UNIT IS ASLEEP,
SWIPE TO WAKE UP
Page - 32
USE ARROWS TO
2
SET TEMPERATURE
Failure to heed the following may result in damage to equipment.
PRESS MENU
A
BUTTON
LED ILLUMINATES AFTER
COMPRESSOR STARTS
USE ARROWS TO
B
"SYSTEM"