Equipment Parameters - Aquacal Water Source WS03 Installation Manual

2.5 Equipment Parameters

This section describes all the possible parameters for equipment that can be connected to the heat pump.
Pumps
Parameter
Name
Pump Type
Port
Minimum Speed
Maximum Speed
Priming Time
Priming Speed
Heat / Cool Speed
Actuators
Parameter
Name
Valve Type
Port
Off Position
Name
On Position
Name
A set of labels is provided for easy identification of the circulation
pump.
A choice between a variable speed or single speed circulation
pump is provided.
This is the connection port where a circlulation pump is connected
to the heat pump.
The connection ports are normally "Port B" on the control board for
l
a variable speed circulation pumps.
And expansion board ports "A" (default), "C", and / or "D" for
l
single speed or multi-speed circulation pumps.
The minimum allowed speed for the circulation pump to operate.
The maximum allowed speed for the circulation pump to operate.
The amount of time allowed to prime the variable speed circulation
pump to remove air bubbles in the lines. Air bubbles would prevent
the water from circulating properly in the system.
The variable speed circulation pump's operating speed when
priming the equipment.
The speed a variable speed circulation pump must run when
actively heating or cooling the water.
A set of labels are provided for easy identification of the circulation
pump's valve actuator.
Currently there is only one choice for this option. (24 VAC
STANDARD).
This is the connection port where the device is connected to the heat
pump's expansion board.
The name of the position that signifies the actuator is inactive.
The name of the position that signifies the actuator is active.
Description
Description
Page - 67