DAKOTA ULTRASONICS CMX DL Operation Manual page 70

Dakota Ultrasonics
3) From the tabbed menus under TUNE, MEASURE MODE.
The steps that follow will demonstrate all three methods in the order listed above:
1) Press the OK key once to use the identified probe, or ESC to display a list of
optional transducers. Note: if the
the user should always select OK to use the identified probe. The only time
an alternative probe should be selected from a list is if the user switched
probes following initial power up and recognition.
2) Assuming the
the
identified as a special transducer capable of measuring coating thickness, a
menu will be displayed allowing the user the ability to toggle the coating
thickness display on/off as follows:
1.800.544.2843
Probe Automatically Recognized (PECT only)
DL
CMX
recognized the probe and the OK key was pressed,
DL
CMX
will advance to a Zero Probe menu. If the transducer was
www.calcert.com
15
10 20
5 25
0 30
DL
CMX
recognizes a specific transducer,
68
sales@calcert.com