DAKOTA ULTRASONICS CMX DL Operation Manual page 29

CLOSE: Provides the user the ability to close a currently opened grid or sequential
log file. Refer to page 110 for further info.
DELETE ONE FILE: This function provides the user with the ability to delete one
individual grid or sequential log file from a list of multiple grids/files previous ly saved
in memory. Refer to page 103 for further info.
DELETE ALL DATA: This function provides the user with the ability to delete all files
currently stored in memory. Refer to page 104 for further info.
3.8 UTIL (utilities) – Menu
SCAN MODE: This function enables a hi speed scan mode that increases the
overall sample rate from 65 to 200 measurements per second, depending on the
current measurement mode used. Refer to page 82 for further info.
ALARM: Toggles alarm mode on, off, or audible . Refer to page 83 for further info.
ALARM HIGH: Gives the user the ability to set the HI limit parameter. If the
measurement exceeds this value, a red light will illuminate and sound the internal
beeper. Refer to page 83 for further info.
ALARM LOW: Gives the user the ability to set the LO limit parameter. If the
measurement falls below this value, a red light will il l uminate and sound the internal
beeper. Refer to page 83 for further info.
DIFFERENTIAL: Gives the user the ability to set a nominal value and the CMX
display +/- the difference from the nominal value entered. Refer to page 85 for
further info.
3.9 XFER (transfer) – Menu
BACKUP SETUPS: Enables the user the ability to backup the setups currently
stored in the CMX
DakView software for a complete electronic manual.
1.800.544.2843
DL
CMX High Performance Material & Coating Thickness Gauge
DL
to a PC via RS232 port. Refer the help section of the CMX
www.calcert.com
15
10 20
5 25
0 30
27
DL
will
DL
sales@calcert.com