DAKOTA ULTRASONICS CMX DL Operation Manual page 42

Dakota Ultrasonics
In this first example the transducer was automatically identified:
1) Press the OK key once to use the identified probe, or ESC to display a list of
optional transducers. Note: if the
the user should always select OK to use the identified probe. The only time
an alternative probe should be selected from a list is if the user switched
probes following initial power up and recognition, or the
somehow identified the probe in error..
2) Assuming the
the
identified as a special transducer capable of measuring coating thickness, a
menu will be displayed allowing the user the ability to toggle the coating
thickness display on/off as follows:
1.800.544.2843
Probe Automatically Recognized
DL
CMX
recognized the probe and the OK key was pressed,
DL
CMX
will advance to a Zero Probe menu. If the transducer was
www.calcert.com
15
10 20
5 25
0 30
DL
CMX
recognizes a specific transducer,
CMX
40
DL
has
sales@calcert.com