DAKOTA ULTRASONICS CMX DL Operation Manual page 6

Dakota Ultrasonics
2.2 Auto Probe Recognition
When the CMX
the transducer plugged into the gauge can be recognized. The steps that follow
assume the CMX
1) Press the OK key once to use the identified probe, or ESC to display a list of
optional transducers. Note: if the
the user should always select OK to use the identified probe. The only time
an alternative probe should be selected from a list is if the user switched
probes following initial power up and recognition.
2) Assuming the
the
identified as a special transducer capable of measuring coating thickness, a
menu will be displayed allowing the user the ability to toggle the coating
thickness display on/off as follows:
1.800.544.2843
DL
is initially powered up, the gauge will automatically check to see if
DL
recognized the probe type:
Probe Automatically Recognized
DL
CMX
recognized the probe and the OK key was pressed,
DL
CMX
will advance to a Zero Probe menu. If the transducer was
www.calcert.com
15
10 20
5 25
0 30
DL
CMX
recognizes a specific transducer,
4
sales@calcert.com