DAKOTA ULTRASONICS CMX DL Operation Manual page 23

5) Repeat steps 3 & 4 until the B-START or B-DEPTH value is correctly
displayed.
6) Press the OK key to set the B-START or B-DEPTH value and return to the
DISP menu, or ESC to cancel entering the B-START or B-DEPTH value.
Note: the adjusted value will appear next to the B-START or B-DEPTH
menu labels.
7)
Finally, press the MEAS key to return to the measurement screen and begin
taking readings.
In the upper left corner of each of the display photos above, is the repeatability
indicator. The repeatability indicator is represented by five vertical bars and
represents how repeatable the measurements are. In regular measurement mode,
the CMX
measurements a second. If the coating mode option is activated, the CMX
3 measurements a second in regular measurement mode and 65 measurements a
second in scan mode. When the CMX
displayed. However, when the CMX
bars should be displayed on the repeatability indicator. If fewer than four bars are
showing, the CMX
thickness value displayed is potentially unstable.
1.800.544.2843
DL
CMX High Performance Material & Coating Thickness Gauge
DIGITS
DL
makes 8 measurements a second. In scan mode, the CMX
DL
is having difficulty achieving a stable measurement and the
www.calcert.com
15
10 20
5 25
0 30
B-SCAN
DL
is idle, only the left vertical bar will be
DL
is making a measurement, four or five of the
21
DL
makes 200
DL
makes
sales@calcert.com