DAKOTA ULTRASONICS CMX DL Operation Manual page 64

Dakota Ultrasonics
5) Press the UP and DOWN arrow keys to scroll the highlighted value.
6) Press the LEFT and RIGHT arrow keys to scroll the digit locations.
7) Repeat steps 5 & 6 until the B-Start value is correctly displayed.
8) Press the OK key to set the B-Start value and return to the menu screen, or
ESC to cancel entering the B-Start.
9) Finally, press the MEAS key to return to the measurement screen and begin
taking readings.
Overall range (B-DEPTH)
Once again, just to reiterate, B-DEPTH is the overall viewable thickness range being
tested. This should be set to a value slightly larger then the expected maximum
range being measured. The procedures to adjust the overall thickness range viewed
(B-DEPTH) are outlined below:
1) Press the MENU key once to activate the menu items tab. Press the MENU
key multiple times to tab right, and the ESC key multiple times to tab left,
until the DISP menu is highlighted and displaying the submenu items.
1.800.544.2843
Adjusting the Overall Depth (B-DEPTH)
www.calcert.com
15
10 20
5 25
0 30
62
sales@calcert.com