SMASH–Lite* Interface
(System Management Architecture for Server Hardware* by AMI*)Intel® Remote Management Module 3 User Guide
8.6.3 Terminating an SOL Session
SOL session can be terminated using the following control key sequence:
CR, ESC, T or t
CARRIAGE RETURN/ENTER key, followed by ESCAPE key, followed by T or t
Control key sequence 'Ctrl + [can be used in place of ESCAPE key].
Once terminated, the control returns to SMASH-Lite* session.
8.7
Enetport1
The BMC in the managed system needs the system's IP Address and MAC Address in order to
be able to respond to UDP/IP packets or generate LAN alerts. Enetport1 (Ethernet port
target) gives the port address information. Enetport1 contains only one target named
lanendpt1.
8.7.1 Supported Properties
The supported properties of the target enetport1 are as follows:
Property
macaddress
Address that was received by the activated session. This read only property gives the
value of the MAC address. Mac address is a unique identifier attached to most
network adaptors (NICs).
Identity
This read only property gives a brief explanation of the present target and cannot be
changed.
8.7.2 Supported Verbs
The supported verbs of the enetport1 target are as follows:
Verb
cd
exit
help
show
version
70
Table 22: Enetport1 - Supported Properties
Table 23: Enetport1 - Supported Verbs
change from one valid target path to any other valid target path.
exit from the current SMASH* session.
provide information on using SMASH*.
show all the targets, properties, and verbs supported by this target.
show the current version of SMASH*.
Task
Is used to
Revision 1.3