Installation On Intel Server Boards S5500Ur And S5500Wb; Figure 4: Installing Intel - Intel Remote Management Module 3 User Manual

Table of Contents

Intel® Remote Management Module 3 User Guide

3.3.1 Installation on Intel

The Intel

Server Board S5500UR and S5500WB install in rack mount 1U or 2U chassis. The

same installation steps apply to both chassis types.

1. Attach the Intel

RMM3 to the metal fastening bracket.

2. Attach the cable from the baseboard to the RMM3 module.

3. Push out and remove the metal cover on the chassis where the NIC RJ-45 receptacle will

align.

4. Mount the RMM3 module to the header on the baseboard and secure the metal fastening

bracket to the back of the chassis as shown in figure 2. This will align the RJ-45 with the

opening in the chassis.

5. Make a note of the MAC address of the Intel

module (not the NIC). Keeping a record now may eliminate the need to reopen the cover

later.

6. Replace the chassis cover, attach AC power and connect a network cable to the Intel

NIC.

Revision 1.3

Server Boards S5500UR and S5500WB

RMM3 on Intel

Hardware Installations and Initial Configuration

RMM3. It is written on a label attached to the

Server Boards S5500UR and S5500WB

RMM

Table of Contents