Hardware Installations And Initial Configuration; Before You Begin; Tools And Supplies Needed; Installation - Intel Remote Management Module 3 User Manual

Hardware Installations and Initial Configuration

3. Hardware Installations and Initial Configuration
This section guides you on the hardware installations and initial configuration.
3.1

Before You Begin

Please read the Safety Information provided at the beginning of this manual before working with
your server product.
3.2

Tools and Supplies Needed

Following are the tools and supplies needed:

Phillips* (cross head) screwdriver (#1 bit and #2 bit)

Needle nosed pliers

Antistatic wrist strap and conductive foam pad (recommended)
3.3

Installation

®
The Intel Remote Management Module 3 is currently supported on the following Intel
boards:

All SKUs of Intel

All SKUs of Intel

All SKUs of Intel

®
The Intel RMM3 Lite is currently supported on all SKU of the Intel
S3420GPRX.

®
The Intel RMM3 Lite-V is currently supported on Intel

All SKUs of the Intel

®
Intel Storage System SR2612UR
®
The Intel RMM3 box contains the following components:

®
Intel Remote Management Module

Network Interface Card (NIC) module

Plastic bag containing screws, slot bracket, 3 plastic standoffs and cabling
The installation will vary between these server boards and their chassis configurations. The
following sections detail installation instructions.
®
Caution: Intel RMM3, RMM3 Lite and RMM3 Lite-V are NOT hot-swappable. Before
removing or replacing it, you must first take the server out of service, turn off the
system by pressing the power button and unplug the AC power cord from the system or
wall outlet and wait for at least 10 seconds before installing the module.
10
®
Server Board S5500BC
®
Server Board S5520HC and S5520SC
®
Server Board SC5520UR
®
Server Board S5500WB
Intel® Remote Management Module 3 User Guide
®
®
Server System SR1640TH.
®
server
Server Board
Revision 1.3