Configuring Intel Rmm3 - Intel Remote Management Module 3 User Manual

Table of Contents

Intel® Remote Management Module 3 User Guide

Configuring Intel

This section discusses using the Server Utilities to enable an Intel

and RMM3 Lite-V, from a new unconfigured state to an operational one.

Note: You can download the IDA and SYSCFG software from the following links:



IDA -

http://www.intel.com/p/en_US/support/highlights/server/ida



SYSCFG -

http://downloadcenter.intel.com/default.aspx



Through BIOS Setup

When first powered on, by default, the Intel

The Intel

RMM3 can be configured in many ways: using the Intel

Sysconfig, and IPMI commands.

The following two steps are necessary before RMM3 can be used:

1. One or both LAN channels must be configured as either DHCP or static addresses.

2. At least one user must be enabled to use the LAN channel(s).

Revision 1.3

RMM3

RMM3 uses a static IP address of 0.0.0.0.

Configuring Intel® RMM3

RMM3, includes RMM3 Lite

> relevant server platforms page

Deployment Assistant (IDA),

Table of Contents