Safety Information - Intel Remote Management Module 3 User Manual

Introduction
Word/Acronym
OOB
PBDE
RMII
RTC
TCP/IP
TPS
UART
UDP
1.3

Safety Information

WARNING
Before working with your Intel
this guide or any other resource as a reference - pay close attention to the
safety instructions. You must adhere to the assembly instructions in this guide
to ensure and maintain compliance with existing product certifications and
approvals. Use only the described regulated components specified in this guide.
Use of other products/components will void the UL listing and other regulatory
approvals of the product and will most likely result in noncompliance with
product regulations in the region(s) in which the product is sold.
Warnings
System power on/off: The server power button DOES NOT turn off the system power or
®
Intel RMM3 power. To remove power from the Intel
power cord from the wall outlet. Make sure the AC power cord is unplugged before you open
the chassis to add or remove the Intel
Hazardous conditions, devices and cables: Hazardous electrical conditions may be
present on power, telephone, and communication cables. Turn off the server and disconnect
the power cord, telecommunications systems, networks, and modems attached to the server
before opening it. Otherwise, personal injury or equipment damage can result.
Electrostatic discharge (ESD) and ESD protection: ESD can damage disk drives, boards,
and other parts. We recommend that you perform all procedures in this chapter only at an
ESD workstation. If one is not available, provide some ESD protection by wearing an
antistatic wrist strap attached to chassis groundany unpainted metal surfaceon your
server when handling parts.
ESD and handling boards: Always handle boards carefully. They can be extremely
sensitive to ESD. Hold boards only by their edges. After removing a board from its protective
wrapper or from the server, place the board component side up on a grounded, static free
surface. Use a conductive foam pad if available but not the board wrapper. Do not slide
board over any surface.
Installing or removing jumpers: A jumper is a small plastic encased conductor that slips
over two jumper pins. Some jumpers have a small tab on top that you can grip with your
fingertips or with a pair of fine needle nosed pliers. If your jumpers do not have such a tab,
take care when using needle nosed pliers to remove or install a jumper; grip the narrow
sides of the jumper with the pliers, never the wide sides. Gripping the wide sides can
2
Out Of Band- No operating system interaction on Server
Polybrominated Biphenyls Diphenyl Ethers
Reduced Media Independent Interface
Real-Time Clock
Transmission Control Protocol/Internet Protocol
Technical Product Specification
Universal Asynchronous Receiver Transmitter
User Datagram Protocol
®
RMM3 server product - whether you are using
®
RMM3.
Intel® Remote Management Module 3 User Guide
Definition
®
RMM3 you must unplug the server AC
Revision 1.3