Advertisement
Quick Links
Advertisement
Related Manuals for Honeywell RFID Kit
Summary of Contents for Honeywell RFID Kit
- Page 1 Printer RFID Kit For PX4ie, PX6ie Installation Guide PX4-6IE-RFID-IG-1Rev A 01/20...
- Page 2 Introduction The RFID kit provides RFID functionality for PX4ie and PX6ie printers. With this kit installed, the PX4ie or PX6ie printer can read and write to RFID tags. These instructions describe how to install the following RFID kits: • PX4ie 915 MHz RFID Kit (P/N 50147009-001) •...
- Page 3 Installing the RFID Kit Warning: The installation described in this section must only be performed by an authorized service technician. Honeywell assumes no responsibility for personal injury or damage to the equipment if the installation is performed by an unauthorized person.
- Page 4 Open the front door and right side door. Remove the eight #T10 Torx screws and remove the left side door. Screw (8 places) PX4ie/PX6ie RFID Kit Installation Guide...
- Page 5 Release the lower media guide latch. Lower media guide latch Carefully remove the lower media guide and upper media guide assembly. Upper and lower media guide assembly Remove the upper media guide from the lower media guide. PX4ie/PX6ie RFID Kit Installation Guide...
- Page 6 Slide the RFID lower media guide into the printer. Insert the pins on the guide into the holes on the print engine base. RFID lower media guide Snap the RFID lower media guide into place. Insert the upper media guide. PX4ie/PX6ie RFID Kit Installation Guide...
- Page 7 1 for slot 1 and connector 2 for slot 2. 13. Slide the RFID interface board into the printer. 14. Secure the RFID interface board with the two screws you removed in Step 9 or with the two included M3x5 screws. PX4ie/PX6ie RFID Kit Installation Guide...
- Page 8 2, use the spacer screw in the kit. 16. Connect the antenna cable to the RFID interface board. 17. Attach the left side door to the printer. 18. Close the front and right side doors. PX4ie/PX6ie RFID Kit Installation Guide...
-
Page 9: Limited Warranty
For patent information, see www.hsmpats.com. Disclaimer Honeywell International Inc. (“HII”) reserves the right to make changes in spec- ifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made.