Profile Series v.N1 Cylindrical Lock
Electrical Installation Guidelines
7
Power and Door Wiring
This diagram depicts the power and door wiring of the v.N1 system. Earth ground and power supply ground must be common
between the power supplies that power the v.N1 components and the electronic access control system; however, these
grounds must not be common to each other.
The wiring for each door consists of five connections between the interface module and the controller inside of the door.
Connections for an external door position switch (if required) are also wired to the door through the hinge.
Note: For a complete guide to all external connections, refer to the v.N1 User Manual (document number A7817).
Interface Module
10
800-810-WIRE (9473) • www.sargentlock.com • A0806B