Partial File Deleted - Northern Telecom DMS-100 Series Maintenance Manual

Procedure 4-28
Disk condition and disk file error messages - procedures
Procedure 4-29
Disk condition and disk file error messages - procedures
1

PARTIAL FILE DELETED

2 Alarm Level:
N/A
3 Customer-Selected
Alarm Level
4 Other Alarm Indications
c.Change the disk mode to PRIME mode.
Enter:
>DISK MODE xx (cr)
where: x = drive
i. For any other response, see the procedure for that
message and perform the activities listed.
ii. If successful, procedure complete. (If
unsuccessful, go to step d.)
d.Replace the disk drive.
i. See Disk Drive Procedures, Replacing Disk Drive,
Procedure 4-9.
ii. Repeat steps a, b, and c. (If unsuccessful, go to
step e.)
e.Call for technical assistance.
End
cause: an incomplete file was successfully deleted. The
file was incomplete due to a failed abort or
downloading session.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type: N/A
Type:
Default:
Status Panel:
Customer-Selected
Status Panel:
DPP Recovery and Routine Maintenance Guide BCS35 and up
Disk drive procedures 4-63
(continued)
(at the terminal)
= A = disk drive A
= B = disk drive B
Proper response = FORMAT DONE
Level: N/A
Level:
Audible:
Audible: