5-10 DPP man-machine interface
Table 5-1
ERRMAP entries to log message cross-reference
ERRMAP message, alarm, level (notes)
Notes:
Note: Refer to Table 5-1 for a description of ERRMAP entries.
Table 5-2
Description of ERRMAP entries
ERRMAP entry, type, level (notes)
STANBY PROC N/A, Major, 0
297-1001-537 Standard 01.02 December 1993
Associated log message(s) (notes)
NO DISK ON LINE
DISK: BOTH DISKS CONTAINED PREFERRED
STATUS
DISK NOT READY SIDE x
DISK: DMA INTERRUPT
DISK: BUS CONTROLLER FAILED SELF TEST
DISK: BUS CONTROLLER FAILED SELF TEST ,
DISK: x
DISK: BUS CONTROLLER INTERRUPT WHILE
IDLE
DISK: COMMAND ERROR
DISK: DISK COMMAND xx ATTEMPTED WHILE
DISK BUSY
DISK: BUS ERROR
DISK: BUS ERROR, m
DISK: BUS DATA TRANSFER BYPASSED
SCSI: INTERRUPT WHILE IDLE
End
Comments (notes)
Cause: comm to the standby processor fails, or
the processor status is non-redundant
(processor ONLY mode).
a. standby processor is powered
down.
b. standby processor is in the monitor
mode.
Test:
on the minute boundary.
(continued)
Need help?
Do you have a question about the DMS-100 Series and is the answer not in the manual?
Questions and answers