Northern Telecom DMS-100 Series Maintenance Manual page 170

4-136 Disk drive procedures
Procedure 4-61
Polling disks from a nonredundant mode
Step Description
23 Enter: (at the terminal)
>RSERR ACT xx (cr)
>RSERR STDBY xx (cr)
where:
xx = device/event number of the
24 The DPP system should now be operating
in a normal, redundant disk mode. For any
other alarms, see the procedure for those
messages in this section and perform the
Craftperson activities listed.
297-1001-537 Standard 01.02 December 1993
alarm (taken from the ERR-
MAP output).
(continued)
Notes
For the active processor.
For the standby processor.
Clear any alarms associated with the
nonredundant disk condition. Examples of
such alarms, as taken from the ERRMAP:
BOTH DISKS FULL
DISK MODE ALARM
RESERV DSK FULL
OFFLIN DSK FULL
DISK USE > 70%
DISK USE > 90%
End