Northern Telecom DMS-100 Series Maintenance Manual page 60

4-26 Disk drive procedures
Procedure 4-12
Disk condition and disk file error messages - procedures
4 Other Alarm Indications
5 System Recovery Action
6 Craftsperson Activity
Procedure 4-13
Disk condition and disk file error messages - procedures
1 (log message)
DISK COMMAND xx AT-
TEMPTED WHILE DISK
BUSY
DISK JOB:
PARAMETERS:
cc(1) cc(2) cc(3)
dd(1) dd(2)
SIDE z
297-1001-537 Standard 01.02 December 1993
Default:
Status Panel: Minor
Customer-Selected
Status Panel:
None; (input is rejected).
Retry input at a later time.
where:
Disk Command = xx = the first two letters of DISK
yy,
aa bb
Disk Job
Directory updates after dynamic relocation:
After a directory track has been relocated:
D0 = read prime
D3 = write prime
(continued)
(continued)
Audible: Minor
Audible:
COMMAND are a two letter code
for the disk command that was
being transferred to or carried out
by the OMTI disk controller
= yy = a two letter code for the disk job
in progress.
= CK = check for ready
D1 = seek prime D2 = seek standby
D4 = write standby