Init Not Allowed (W/O 56K Polling) - Northern Telecom DMS-100 Series Maintenance Manual

Procedure 4-24
Disk condition and disk file error messages - procedures
Notes:
Note 1: Use the DISK FORMAT x command only in extreme emergencies and then under the direction of NT field support.
Note 2: Make sure the operational disk drive is in DISK ONLY mode before entering commands.
Procedure 4-25
Disk condition and disk file error messages - procedures
1
INIT NOT ALLOWED
(w/o 56K polling)
2 Alarm Level:
N/A
i. The recommended procedure is Procedure 4-5.
ii. The alternate procedure is Procedure 4-6. (When
init activity is complete, go to step c.)
c.Change the disk to PRIME mode.
Enter: (at the terminal)
>DISK MODE xx (cr)
i. For any other response, see the procedure for that
message and perform the activities listed.
ii. If successful, procedure complete. (If
unsuccessful, go to step d.)
d.Call for technical assistance.
End
cause: printed in response to the DISK INIT command
when the specified disk drive is on line.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type: N/A
(continued)
DPP Recovery and Routine Maintenance Guide BCS35 and up
Disk drive procedures 4-55
(continued)
where: xx = disk mode
= AP = A PRIME
= BP = B PRIME
Proper response = DISK MODE: AP
DISK MODE: BP
Level: N/A
or
1